2. Specifications for Intel FPGA Download Cable

The Intel FPGA Download Cable has a universal USB connector that plugs into the PC

USB port, and a female connector that plugs into a male header on the device board.

This section shows the hardware components, their dimensions, and lists the pins,

operating conditions and power requirements.

2.1. Block Diagram and Dimension

Figure 1.

Block Diagram of the Intel FPGA Download Cable

Chip

USB Interface

EPM7064AETC44

I/Os

I/Os

Pin 1

VCC

I/O

I/O

I/O

I/O

I/O

I/O

I/O

I/O

USBVCC

Receptacle

USB

10-P in

Female Plug

Voltag e Translator

Circuitry

Figure 2.

Dimension of the Intel FPGA Download Cable

2.5

1.0

2.0

(1) Applies to Rev. B and Rev. C.

All Dimensions are in inches.

2.2. Cable-to-Board Connection

TheIntel FPGA Download Cable has a 10-pin female connector, which plugs into a 10-

pin male header on the device board. The male header consists of two rows of five

pins, which are connected to the programming or configuration pins of the device.

UG-USB81204 | 2020.03.11

Send Feedback

Intel Corporation. All rights reserved. Agilex, Altera, Arria, Cyclone, Enpirion, Intel, the Intel logo, MAX, Nios,

Quartus and Stratix words and logos are trademarks of Intel Corporation or its subsidiaries in the U.S. and/or

other countries. Intel warrants performance of its FPGA and semiconductor products to current specifications in

accordance with Intel's standard warranty, but reserves the right to make changes to any products and services

at any time without notice. Intel assumes no responsibility or liability arising out of the application or use of any

information, product, or service described herein except as expressly agreed to in writing by Intel. Intel

customers are advised to obtain the latest version of device specifications before relying on any published

information and before placing orders for products or services.

*Other names and brands may be claimed as the property of others.

ISO

9001:2015

Registered