9 Application and Implementation

Note

Information in the following applications sections is not part of the TI component specification, and

TI does not warrant its accuracy or completeness. TI’s customers are responsible for determining

suitability of components for their purposes. Customers should validate and test their design

implementation to confirm system functionality.

9.1 Application Information

The SN74HCS153-Q1 is a dual 4-to-1 data selector/multiplexer. This application shows an example of using the

device with all required connections to switch between four 2-bit data sources.

9.2 Typical Application

System

Controller

2:4

DECODER

A

B

2G

GND

1C1

1C2

1C0

1C3

Device 0

Device 1

Device 2

Device 3

1Y

0.1…F

2Y

1G

2C1

2C2

2C0

2C3

D0A

D0B

D1A

D1B

D2A

D2B

D3A

D3B

D0A

D0B

D1A

D1B

D2A

D2B

D3A

D3B

DXA

DXB

Figure 9-1. Typical application block diagram

9.2.1 Design Requirements

9.2.1.1 Power Considerations

Ensure the desired supply voltage is within the range specified in the Recommended Operating Conditions. The

supply voltage sets the device's electrical characteristics as described in the Electrical Characteristics.

The positive voltage supply must be capable of sourcing current equal to the total current to be sourced by all

and any transient current required for switching. The logic device can only source as much current as is provided

Absolute Maximum Ratings.

The ground must be capable of sinking current equal to the total current to be sunk by all outputs of the

current required for switching. The logic device can only sink as much current as can be sunk into its ground

connection. Be sure not to exceed the maximum total current through GND listed in the Absolute Maximum

Ratings.

The SN74HCS153-Q1 can drive a load with a total capacitance less than or equal to 50 pF while still meeting

all of the datasheet specifications. Larger capacitive loads can be applied, however it is not recommended to

exceed 50 pF.

the output voltage in the equation is defined as the difference between the measured output voltage and the

www.ti.com

SN74HCS153-Q1

SCLS817A – AUGUST 2020 – REVISED DECEMBER 2021

Copyright © 2021 Texas Instruments Incorporated

Submit Document Feedback

13

Product Folder Links: SN74HCS153-Q1