info@magigoo.com

www.magigoo.com

MAGIGOO

Thought3D Ltd, Unit2150, KBIC, Kordin Industrial Estate

Paola, PLA3000, Malta

Application Method:

NB! The Magigoo – Polypropylene container is spring activated.

Pressing the bottle without pressing the nib against the bed may

result in applicator popping off and product wastage.

NB! After print, wait until the build plate is cool to remove prints

easily.

It is recommended to gently peel away the brim around the part

and then attempting to remove the part by hand. If the part is

hard to remove, a scraper should be used to assist part removal.

In cases of excess adhesion, it is recommended to wet print bed

with a small amount of water slowly working it below the part.

This should make part removal easier.

NB! Use a wet sponge to remove all glue residue. Once the glue

layer is wet it will form a white layer which can be easily scrubbed

off with an abrasive sponge. Once the layer is completely loose

from the glass it can be wiped away with a wet cloth and finally

cleaned with a dry paper towel.

3

* Images are illustrative.

Spring activated valve

inside