LSM6DSO32 datasheet(37/153 Pages) STMICROELECTRONICS

37 / 153 page

DocID032891 Rev 1

37/153

LSM6DSO32

Digital interfaces

153

5.1.2

SPI bus interface

The LSM6DSO32 SPI is a bus slave. The SPI allows writing and reading the registers of the

device.

The serial interface communicates to the application using 4 wires: CS, SPC, SDI and SDO.

Figure 7. Read and write protocol (in mode 3)

CS is the serial port enable and it is controlled by the SPI master. It goes low at the start of

the transmission and goes back high at the end. SPC is the serial port clock and it is

controlled by the SPI master. It is stopped high when CS is high (no transmission). SDI and

SDO are, respectively, the serial port data input and output. Those lines are driven at the

falling edge of SPC and should be captured at the rising edge of SPC.

Both the read register and write register commands are completed in 16 clock pulses or in

multiples of 8 in case of multiple read/write bytes. Bit duration is the time between two falling

edges of SPC. The first bit (bit 0) starts at the first falling edge of SPC after the falling edge

of CS while the last bit (bit 15, bit 23, ...) starts at the last falling edge of SPC just before the

rising edge of CS.

bit 0: RW bit. When 0, the data DI(7:0) is written into the device. When 1, the data DO(7:0)

from the device is read. In latter case, the chip will drive SDO at the start of bit 8.

bit 1-7: address AD(6:0). This is the address field of the indexed register.

bit 8-15: data DI(7:0) (write mode). This is the data that is written into the device (MSb first).

bit 8-15: data DO(7:0) (read mode). This is the data that is read from the device (MSb first).

In multiple read/write commands further blocks of 8 clock periods will be added. When the

CTRL3_C (12h) (IF_INC) bit is ‘0’, the address used to read/write data remains the same for

every block. When the CTRL3_C (12h) (IF_INC) bit is ‘1’, the address used to read/write

data is increased at every block.

The function and the behavior of SDI and SDO remain unchanged.

LSM6DSO32 데이터시트(PDF) 37 Page - STMicroelectronics