Wire the receiver module to another Arduino by following the next schematic diagram.

Note

: always check the pinout for the receiver module you’re using. Usually, there are

labels next to the pins.

Alternatively, you can also take a look at your module’s

datasheet.

Receiver Sketch

Upload the code below to the Arduino connected to the receiver.

#include

#include

// Not actualy used but needed to compile

RH_ASK driver;

void setup()

{

Serial.begin(9600);

// Debugging only

if (!driver.init())

Serial.println("init failed");

}

void loop()

{

uint8_t buf[12];