LS-T3 datasheet(12/64 Pages) IDEC

12 / 64 page

ø16 X6 Series Emergency Stop Switches (Unibody)

Instructions

Panel Mounting

Remove the locking ring from the operator and check that

the rubber gasket is in place. Insert the operator from panel

front into the panel hole. Face the side with the projection

upward, and tighten the locking ring using the locking ring

wrench MT-001.

Projection

Rubber Gasket

Locking Ring

Operator

Notes for Panel Mounting

Using the locking ring wrench MT-001, tighten the locking

ring to a torque of 0.88 N·m. Do not use pliers. Do not apply

excessive force, otherwise the locking ring will become

damaged.

Wiring

1. Applicable wire size is 1.25 mm2 maximum.

2. Solder the terminals using a soldering iron at 310 to 350°C

for 3 seconds maximum. Do not use flow or dip soldering.

SnAgCu type lead-free solder is recommended. Make

sure that the soldering iron touches the terminals only, not

plastic parts. Do not apply external force such as bending

the terminals or applying tensile force on the wires.

3. Use a non-corrosive rosin flux. To prevent the flux from

entering the switch while soldering, face the terminals

downward.

4. Because the terminal spacing is narrow, use protective

tubes or heat shrinkable tubes to avoid burning the wire

sheath or short circuit.

5. Apply force on the terminals in the vertical direction to the

panel only, otherwise the terminals will be damaged.

Contact Bounce

When the button is reset by pulling or turning, the NC

contacts will bounce. When designing a control circuit, take

the contact bounce time into consideration (reference value:

20 ms).

Handling

Do not expose the switch to excessive shock and vibrations,

otherwise the switch may be deformed or damaged, causing

malfunction or operation failure.

• Turn off power to the X6 series units before installation, removal,

wiring, maintenance, and inspection. Failure to turn power off

may cause electrical shocks or fire hazard.

• For wiring, use wires of proper size to meet the voltage

and current requirements and solder properly. Improper

soldering may cause overheating and create fire hazards.

Correct

Incorrect

Safety Precautions

LS-T3 데이터시트(PDF) 12 Page - IDEC Corporation

LS-T3 데이터시트(HTML) 12 Page - IDEC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

데이터시트 다운로드

링크 URL