LS-T3 datasheet(57/64 Pages) IDEC

57 / 64 page

HN Series Emergency Stop Switches ø30

Panel Mounting

Tighten the locking ring using ring wrench XN9Z-T1 or

TWST-T1 to a torque of 2.0 N·m maximum. Do not use

pliers. Excessive tightening will damage the locking ring.

Installing and Removing the Lens

There is a groove each on the right and left of the lens.

Insert a flat screwdriver into one of them and push upward.

Take care not lose a lens.

Replacing the LED lamp

Use the lamp holder tool (OR-55) to replace the LED lamp

from the front of the panel.

[How to Remove]

To remove, slip the lamp holder tool (OR-55) onto the lamp

head lightly. Then push slightly, and turn the lamp holder

tool counterclockwise.

[How to Install]

To install, insert the lamp head into the lamp holder tool

(OR-55).

Lamp

Lamp Holder Tool

Place the pins on the lamp base to the grooves in the lamp

socket. Inset the lamp and turn it clockwise.

Base

Do not apply excessive force onto the lamp in the base,

otherwise the base will be damaged.

Notice on Wiring

When wiring, provide sufficient insulation between wires

(crimping terminals).

Recommended Tightening Torque

1.0 to 1.3 N∙m

• Turn off the power to the HN series before starting installa-

tion, removal, wiring, maintenance, and inspection. Failure

to turn power off may cause electrical shocks or fire haz-

ard.

• To avoid a burn on your hand, use the lamp holder tool

when replacing lamps.

• For wiring, use wires of a proper size to meet the volt-

age and current requirements. Tighten the M3.5 terminal

screws to a tightening torque of 1.0 to 1.3 N·m. Failure to

tighten terminal screws may cause overheat and fire.

Safety Precautions

Operating Instructions

LS-T3 데이터시트(PDF) 57 Page - IDEC Corporation

LS-T3 데이터시트(HTML) 57 Page - IDEC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

데이터시트 다운로드

링크 URL