LTC2292UP datasheet(16/28 Pages) LINER

16 / 28 page

LTC2293/LTC2292/LTC2291

229321f

sensitive applications, the analog inputs can be driven

single-ended with slightly worse harmonic distortion. The

CLK input is single-ended. The LTC2293/LTC2292/

LTC2291 have two phases of operation, determined by the

state of the CLK input pin.

Each pipelined stage shown in Figure 1 contains an ADC,

a reconstruction DAC and an interstage residue amplifier.

In operation, the ADC quantizes the input to the stage and

the quantized value is subtracted from the input by the

DAC to produce a residue. The residue is amplified and

output by the residue amplifier. Successive stages operate

out of phase so that when the odd stages are outputting

their residue, the even stages are acquiring that residue

and vice versa.

When CLK is low, the analog input is sampled differentially

directly onto the input sample-and-hold capacitors, inside

the “Input S/H” shown in the block diagram. At the instant

that CLK transitions from low to high, the sampled input is

held. While CLK is high, the held input voltage is buffered

by the S/H amplifier which drives the first pipelined ADC

stage. The first stage acquires the output of the S/H during

this high phase of CLK. When CLK goes back low, the first

stage produces its residue which is acquired by the

second stage. At the same time, the input S/H goes back

to acquiring the analog input. When CLK goes back high,

the second stage produces its residue which is acquired

by the third stage. An identical process is repeated for the

APPLICATIO S I FOR ATIO

third, fourth and fifth stages, resulting in a fifth stage

residue that is sent to the sixth stage ADC for final

evaluation.

Each ADC stage following the first has additional range to

accommodate flash and amplifier offset errors. Results

from all of the ADC stages are digitally synchronized such

that the results can be properly combined in the correction

logic before being sent to the output buffer.

SAMPLE/HOLD OPERATION AND INPUT DRIVE

Sample/Hold Operation

Figure 2 shows an equivalent circuit for the LTC2293/

LTC2292/LTC2291 CMOS differential sample-and-hold.

The analog inputs are connected to the sampling capaci-

tors (CSAMPLE) through NMOS transistors. The capacitors

shown attached to each input (CPARASITIC) are the summa-

tion of all other capacitance associated with each input.

During the sample phase when CLK is low, the transistors

connect the analog inputs to the sampling capacitors and

they charge to and track the differential input voltage.

When CLK transitions from low to high, the sampled input

voltage is held on the sampling capacitors. During the hold

phase when CLK is high, the sampling capacitors are

disconnected from the input and the held voltage is passed

to the ADC core for processing. As CLK transitions from

high to low, the inputs are reconnected to the sampling

Figure 2. Equivalent Input Circuit

VDD

15Ω

CPARASITIC

1pF

CPARASITIC

1pF

CSAMPLE

4pF

CSAMPLE

4pF

LTC2293/LTC2292/LTC2291

AIN

–

CLK

229321 F02

LTC2292UP 데이터시트(PDF) 16 Page - Linear Technology

LTC2292UP 데이터시트(HTML) 16 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

데이터시트 다운로드

링크 URL