HC5503PRC

FN4806 Rev.3.00

Page 6 of 11

June 2004

15

15

PD

Power Denial - A low active TTL - Compatible logic input. When enabled, the ring feed voltage collapses

to the tip feed voltage (~4V). The DC feed is disabled, but the AC transmission is maintained. The switch

hook detect (SHD) is not necessarily valid, and the relay driver (RD) output is disabled.

16

16

RC

Ring Command - A low active TTL - Compatible logic input. When enabled, the relay driver (RD) output

goes low on the next high level of the ring sync (RS) input, as long as the SLIC is not in the power denial

state (PD = 0) or the subscriber is not already off- hook (SHD = 0).

17

NC

Leave disconnected.

18

20

OUT

The analog output of the spare operational amplifier.

19

21

-IN

The inverting analog input of the spare operational amplifier.

20

22

+IN

The non-inverting analog input of the spare operational amplifier.

21

23

RX

Receive Input, Four Wire Side - A high impedance analog input which is internally biased. Capacitive

coupling to this input is required. AC signals appearing at this input differentially drive the Tip feed and

Ring feed terminals.

22

25

C2

Capacitor #2 - An external capacitor to be connected between this terminal and analog ground. This

capacitor is required for the proper operation of ring trip detection. Recommended value 0.82

F 10%

10V non-polarized.

23

26

AG

Analog Ground - To be connected to zero potential and serves as a reference for the transmit output (TX)

and receive input (RX) terminals.

24

27

TX

Transmit Output, Four Wire Side - A low impedance analog output proportional to the loop current.

Transhybrid balancing must be performed beyond this output to completely implement two to four wire

conversion. This output is unbalanced and referenced to analog ground. Since the DC level of this output

varies with loop current, capacitive coupling to the next stage is essential.

2, 17,

18,24, 29,

30,

NC

No internal connection.

NOTE: All grounds (AG, BG, and DG) must be applied before VB+ or VB-. Failure to do so may result in premature failure of the part. If a user wishes

to run separate grounds off a line card, the AG must be applied first.

Pin Descriptions (Continued)

24 PIN

DIP/SOIC

7 x 7

QFN

SYMBOL

DESCRIPTION