| 전자부품 데이터시트 검색엔진 |
|
COM20020D 데이터시트(PDF) 33 Page - SMSC Corporation |
|
|
|||||||||||||||||||||||||||||
COM20020D 데이터시트(HTML) 33 Page - SMSC Corporation |
|
33 / 72 page ![]() 33 Table 10 - Configuration Register 4,3 Extended Timeout 1,2 ET1, ET2 These bits allow the network to operate over longer distances than the default maximum 2 miles by controlling the Response, Idle, and Reconfiguration Times. All nodes should be configured with the same timeout values for proper network operation. For the COM20020D with a 20 MHz crystal oscillator, the bit combinations follow: ET2 0 0 1 1 ET1 0 1 0 1 Response Time ( µS) 596.6 298.4 149.2 37.4 Idle Time ( µS) 656 328 164 41 Reconfig Time (mS) 840 840 840 420 Note: These values are for 5Mbps and RCNTMR[1,0]=00. Reconfiguration time is changed by the RCNTMR1 and RCNTMR0 bits. 2 Backplane BACK- PLANE A logic "1" on this bit puts the device into Backplane Mode signaling which is used for Open Drain and Differential Driver interfaces. 1,0 Sub Address 1,0 SUBAD 1,0 These bits determine which register at address 07 may be accessed. The combinations are as follows: SUBAD1 SUBAD0 Register 0 0 Tentative ID 0 1 Node ID 1 0 Setup 1 1 1 Next ID See also the Sub Address Register. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |