HT360 datasheet(31/46 Pages) HANTEK

31 / 46 page

Function introduction

HT360 series user manual

Function introduction

5.1

Measuring interface

After the instrument is started, it will enter the measurement interface. If it is in any

other interface, just press

to enter the measurement interface;

Each time the material is switched, the hardness scale is changed to Leeb, so the

material should be set first and then the hardness scale;

Under normal conditions, the current measured value cannot be stored when the set

number of impacts is not reached;

The measurement interface mainly displays the measuring impact device, measuring

material, current measured value, measuring times and average value. When the

measurement times reach the set number, the average value changes from white to

green. The display page is as follows:

Figure 5 Measurement Interface

1 Impact device

The instrument supports 5 types of impact devices, namely D, DC, DL, D+15 and G,

which are automatically identified during replacement, and no calibration is required.

2 Measuring direction

It supports vertical downward, oblique downward, horizontal, oblique upward and

vertical upward.

3 Measuring average

4 Measuring materials

The measured materials include steel and cast steel, alloy tool steel, stainless steel,

gray cast iron, ductile iron, cast aluminum alloy, copper zinc alloy (brass), copper tin

alloy (bronze), pure copper and forged steel.

5 Hardness scale

HT360 데이터시트(PDF) 31 Page - Qingdao Hantek Electronic Co., Ltd.