HT360 datasheet(35/46 Pages) HANTEK

35 / 46 page

Function introduction

HT360 series user manual

Figure5 Printing Paper

1 Printer: Press the power on key

, and the indicator will flash blue.

2 Hardness tester: Main interface > Print > Connect, the instrument displays

"Connecting the printer...". At this time, the instrument cannot be operated. After about

one minute, when the printer successfully connects to the device, the printer blue light

is off, printing can be performed.

During printing of multiple measured values, press

to stop the current printing.

Function

Description

Link State

Displays the connection status between the instrument and

the printer.

Curr Value

Print the current measured value. If the current measurement

is not completed, prompt "Measurement is not completed" and

no printing will be performed.

Group Set

Press

to select one of the 10 groups.

Value Set

Select some values to print in some print groups.

Print All

Print all the values in all print groups selected

Table 5 Print menu functions

5.8

Firmware upgrade

1. Download and install the burning tool "DfuSe Demo v3.0.5". Download the upgrade

package (* * *. dfu).

2. In the shutdown state, insert the USB cable into the Type C port of the instrument,

and the instrument is connected to the computer. Keep holding down the

key,

gently press the power key and release it. At this time, the indicator light in the lower

right corner starts flashing red and green, indicating that the instrument has entered the

Dfu mode. Release F1 key.

HT360 데이터시트(PDF) 35 Page - Qingdao Hantek Electronic Co., Ltd.