PCF8593P datasheet(14/28 Pages) PHILIPS

14 / 28 page

1997 Mar 25

Philips Semiconductors

Product speciﬁcation

Low power clock/calendar

PCF8593

7.10

Oscillator and divider

A 32.768 kHz quartz crystal has to be connected to OSCI

(pin 1) and OSCO (pin 2). A trimmer capacitor between

OSCI and VDD is used for tuning the oscillator (see

Chapter 14, Section 14.1). A 100 Hz clock signal is derived

from the quartz oscillator for the clock counters.

In the 50 Hz clock mode or event-counter mode the

oscillator is disabled and the oscillator input is switched to

a high-impedance state. This allows the user to feed the

50 Hz reference frequency or an external high-speed

event signal into the input OSCI.

7.10.1

DESIGNING

When designing the printed-circuit board layout, keep the

oscillator components as close to the IC package as

possible, and keep all other signal lines as far away as

possible. In applications involving tight packing of

components, shielding of the oscillator may be necessary.

AC coupling of extraneous signals can introduce oscillator

inaccuracy.

7.11

Initialization (see Fig.12)

Note that immediately following power-on, all internal

registers are undefined and, following a RESET pulse on

pin 3, must be defined via software. Attention should be

paid to the possibility that the device may be initially in

event-counter mode, in which event the oscillator will not

operate. Over-ride can be achieved via software.

Reset is accomplished by applying an external RESET

pulse (active LOW) at pin 3. When reset occurs only the

I2C-bus interface is reset. The control/status register and

all clock counters are not affected by RESET. RESET

must return HIGH during device operation.

An RC combination can also be utilized to provide a

power-on RESET signal at pin 3. In this event, the values

of the RC must fulfil the following relationship to guarantee

power-on reset (see Fig.12).

RESET input must be

≤0.3VDD when VDD reaches VDDmin

(or higher).

It is recommended to set the stop counting flag of the

control/status register before loading the actual time into

the counters. Loading of illegal states may lead to a

temporary clock malfunction.

Fig.12 RC reset.

To avoid overload of the internal diode by falling VDD, an external

diode should be added in parallel to RR if CR ≥ 0.2 µF. Note that RC

must be evaluated with the actual VDD of the application, as their

value will be VDD rise-time dependent.

handbook, halfpage

MBD819

RESET

C R

R R

reset

input

VDD

PCF8593

VDD

PCF8593P 데이터시트(PDF) 14 Page - NXP Semiconductors

PCF8593P 데이터시트(HTML) 14 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

데이터시트 다운로드

링크 URL