AD9910SLASHPCBZ datasheet(39/60 Pages) AD

39 / 60 page

AD9910

Rev. 0 | Page 39 of 60

WAVEFORM START ADDRESS

WAVEFORM END ADDRESS

RAM ADRESS

RAM_SWP_OVER

I/O_UPDATE

M DDS CLOCK CYCLES

Figure 47. Continuous Bidirectional Ramp Timing Diagram

A change in state of the profile pins aborts the current waveform

and the newly selected RAM profile is used to initiate a new

waveform.

The RAM_SWP_OVR pin switches to Logic 1 when the state

machine reaches the waveform end address, then returns to

Logic 0 at the waveform start address, toggling each time one

of these addresses is reached.

A graphic representation of the continuous bidirectional ramp

mode is shown in Figure 47. The circled numbers indicate specific

events as follows:

Event 1—An I/O update or profile change has activated the RAM

continuous bidirectional ramp mode. The state machine initializes

to the waveform start address. The RAM_SWP_OVR pin resets to

Logic 0. The state machine begins incrementing through the

specified address range.

Event 2—The state machine reaches the waveform end address.

The RAM_SWP_OVR pin toggles to Logic 1.

Event 3—The state machine reaches the waveform start address.

The RAM_SWP_OVR pin toggles to Logic 0.

This action continues indefinitely until the next I/O update or

change in profile.

AD9910/PCBZ 데이터시트(PDF) 39 Page - Analog Devices