56F802 datasheet(18/40 Pages) FREESCALE

18 / 40 page

56F802 Technical Data, Rev. 9

Freescale Semiconductor

Figure 3-1 Maximum Run IDD vs. Frequency (see Note 6. in Table 3-4)

3.3 AC Electrical Characteristics

Timing waveforms in Section 3.3 are tested using the VIL and VIHlevels specified in the DC Characteristics

table. In Figure 3-2 the levels of VIH and VIL for an input signal are shown.

Figure 3-2 Input Signal Measurement References

Figure 3-3 shows the definitions of the following signal states:

•

Active state, when a bus or signal is driven, and enters a low impedance state

•

Tri-stated, when a bus or signal is placed in a high impedance state

10. Power

–on reset occurs whenever the internally regulated 2.5V digital supply drops below 1.5V typical. While power is ramping up,

this signal remains active for as long as the internal 2.5V is below 1.5V typical no matter how long the ramp up rate is. The internally

regulated voltage is typically 100 mV less than VDD during ramp up until 2.5V is reached, at which time it self regulates.

120

160

Freq. (MHz)

IDD Digital

IDD Analog

IDD Total

VIH

VIL

Fall Time

Input Signal

Note: The midpoint is VIL + (VIH – VIL)/2.

Midpoint1

Low

High

90%

50%

10%

Rise Time

56F802 데이터시트(PDF) 18 Page - Freescale Semiconductor, Inc