M68HC05 datasheet(39/118 Pages) FREESCALE

39 / 118 page

MC68HC05C9A Advance Information Data Sheet, Rev. 4.1

Freescale Semiconductor

Chapter 5

Resets

5.1 Introduction

The MCU can be reset four ways: by the initial power-on reset function, by an active low input to the

RESET pin, by the COP, or by the clock monitor. A reset immediately stops the operation of the instruction

being executed, initializes some control bits, and loads the program counter with a user-defined reset

vector address. Figure 5-1 is a block diagram of the reset sources.

Figure 5-1. Reset Sources

5.2 Power-On Reset (POR)

A power-on-reset occurs when a positive transition is detected on VDD. The power-on reset is strictly for

power turn-on conditions and should not be used to detect a drop in the power supply voltage. There is a

4064 internal processor clock cycle (tcyc) oscillator stabilization delay after the oscillator becomes active.

(When configured as a C9A, the RESET pin will output a logic 0 during the 4064-cycle delay.) If the

RESET pin is low after the end of this 4064-cycle delay, the MCU will remain in the reset condition until

RESET is driven high externally.

5.3 RESET Pin

The function of the RESET pin is dependent on whether the device is configured as an MC68HC05C9A

or an MC68HC05C12A. When it is in the MC68HC05C12A configuration, the pin is input only. When in

MC68HC05C9A configuration the pin is bidirectional. In both cases the MCU is reset when a logic 0 is

applied to the RESET pin for a period of one and one-half machine cycles (t

). For the MC68HC05C9A

configuration, the RESET pin will be driven low by a COP, clock monitor, or power-on reset.

VDD

RESET

LATCH

POWER-ON RESET

INTERNAL CLOCK

RST

TO CPU AND

SUBSYSTEMS

STOP

CLOCK MONITOR

COP WATCHDOG

M68HC05 데이터시트(PDF) 39 Page - Freescale Semiconductor, Inc