| 전자부품 데이터시트 검색엔진 |
|
LLCC68 데이터시트(PDF) 69 Page - Semtech Corporation |
|
|
|||||||||||||||||||||||||||||
LLCC68 데이터시트(HTML) 69 Page - Semtech Corporation |
|
69 / 106 page ![]() LLCC68 Data Sheet Rev. 1.0 DS.LLCC68.W.APP July 2019 69 of 106 Semtech www.semtech.com While this command has no real use case in real life, it can provide valuable help to the developer to check and monitor the performances of the radio while in Tx mode. 13.1.10 SetTxInfinitePreamble SetTxInfinitePreamble() is a test command to generate an infinite sequence of alternating zeros and ones in FSK modulation. In LoRa®, the radio is only able to constantly modulate LoRa® preamble symbols. The device will remain in TX infinite preamble until the host sends a mode configuration command. While this command has no real use case in real life, it can provide valuable help to the developer to check and monitor the performances of the radio while modulating in Tx mode. However, when using this function, it is impossible to define any data sent by the device. In LoRa® mode, the radio is only able to constantly modulate LoRa preamble symbols and, in FSK mode, the radio is only able to generate FSK preamble (0x55). Nevertheless, the end user will be able to easily monitor the spectral impact of its modulation parameters. 13.1.11 SetRegulatorMode By default only the LDO is used. This is useful in low cost applications where the cost of the extra self needed for a DC-DC converter is prohibitive. Using only a linear regulator implies that the RX or TX current is almost doubled. This function allows to specify if DC-DC or LDO is used for power regulation. The regulation mode is defined by parameter regModeParam. Note: This function is clearly related to the hardware implementation of the device. The user should always use this command while knowing what has been implemented at the hardware level. Table 13-15: SendTxInfinitePreamble SPI Transaction Byte 0 Data from host Opcode = 0xD2 Table 13-16: SetRegulatorMode SPI Transaction Byte 0 1 Data from host Opcode= 0x96 regModeParam 0: Only LDO used for all modes 1: DC_DC+LDO used for STBY_XOSC,FS, RX and TX modes |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |