PIC12F683-ESLASHMDQTP datasheet(80/176 Pages) MICROCHIP

80 / 176 page

PIC12F683

DS41211D-page 78

11.3

PWM Mode

The PWM mode generates a Pulse-Width Modulated

signal on the CCP1 pin. The duty cycle, period and

resolution are determined by the following registers:

•PR2

•T2CON

• CCPR1L

• CCP1CON

In Pulse-Width Modulation (PWM) mode, the CCP

module produces up to a 10-bit resolution PWM output

on the CCP1 pin. Since the CCP1 pin is multiplexed

with the PORT data latch, the TRIS for that pin must be

cleared to enable the CCP1 pin output driver.

Figure 11-1 shows a simplified block diagram of PWM

operation.

Figure 11-4 shows a typical waveform of the PWM

signal.

For a step-by-step procedure on how to set up the CCP

module for PWM operation, see Section 11.3.7

“Setup for PWM Operation”.

FIGURE 11-3:

SIMPLIFIED PWM BLOCK

DIAGRAM

The PWM output (Figure 11-4) has a time base

(period) and a time that the output stays high (duty

cycle).

FIGURE 11-4:

CCP PWM OUTPUT

Note:

Clearing

the

CCP1CON

will

relinquish CCP1 control of the CCP1 pin.

CCPR1L

CCPR1H(2) (Slave)

Comparator

TMR2

PR2

(1)

Duty Cycle Registers

CCP1CON<5:4>

Clear Timer2,

toggle CCP1 pin and

latch duty cycle

Note

The 8-bit timer TMR2 register is concatenated

with the 2-bit internal system clock (FOSC), or

2 bits of the prescaler, to create the 10-bit time

base.

In PWM mode, CCPR1H is a read-only register.

TRIS

CCP1

Comparator

Period

Pulse Width

TMR2 = 0

TMR2 = CCPR1L:CCP1CON<5:4>

TMR2 = PR2

PIC12F683-E/MDQTP 데이터시트(PDF) 80 Page - Microchip Technology

PIC12F683-E/MDQTP 데이터시트(HTML) 80 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL