CS8420-CSZ datasheet(83/94 Pages) CIRRUS

83 / 94 page

DS245F4

CS8420

15.1.2

Reserving the First 5 Bytes in the E Buffer

D-to-E buffer transfers periodically overwrite the data stored in the E buffer. This can be a problem for

users who want to transmit certain channel status settings which are different from the incoming settings.

In this case, the user would have to superimpose his settings on the E buffer after every D-to-E overwrite.

To avoid this problem, the CS8420 has the capability of reserving the first 5 bytes of the E buffer for user

writes only. When this capability is in use, internal D-to-E buffer transfers will NOT affect the first 5 bytes

of the E buffer. Therefore, the user can set values in these first 5 E bytes once, and the settings will persist

until the next user change. This mode is enabled via the Channel Status Data Buffer Control register.

15.1.3

Serial Copy Management System (SCMS)

In Software mode, the CS8420 allows read/modify/write access to all the channel status bits. For Con-

sumer mode SCMS compliance, the host microcontroller needs to read and manipulate the Category

Code, Copy bit and L bit appropriately.

In Hardware mode, the SCMS protocol can be followed by either using the COPY and ORIG input pins,

or by using the C bit serial input pin. These options are documented in the Hardware mode section of this

data sheet (See “Hardware Modes” on page 55)

15.1.4

Channel Status Data E Buffer Access

The E buffer is organized as 24 x 16-bit words. For each word the MS Byte is the A channel data, and the

LS Byte is the B channel data (see Figure 37).

There are two methods of accessing this memory, known as one-byte mode and two-byte mode. The de-

sired mode is selected via a control register bit.

E to Finterrupt occurs

Optionally set E to F inhibit

Clear D to E inhibit

If set, clear E to F inhibit

Return

Set D to E inhibit

Write E data

Wait for E to F transfer

Figure 40. Flowchart for Writing the E Buffer

CS8420-CSZ 데이터시트(PDF) 83 Page - Cirrus Logic