PM7366-PI datasheet(255/286 Pages) PMC

255 / 286 page

RELEASED

PM7366 FREEDM-8

DATA SHEET

PMC-1970930

ISSUE 4

FRAME ENGINE AND DATA LINK MANAGER

PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA,INC., AND FOR ITS CUSTOMERS’ INTERNAL USE

242

All 8 framers in the TOCTL should be programmed to operate in “Clock Master: NxDS0” mode in

both the ingress and egress direction.

13.3 JTAG Support

The FREEDM-8 supports the IEEE Boundary Scan Specification as described in the IEEE 1149.1

standards. The Test Access Port (TAP) consists of the five standard pins, TRSTB, TCK, TMS,

TDI and TDO used to control the TAP controller and the boundary scan registers. The TRSTB

input is the active low reset signal used to reset the TAP controller. TCK is the test clock used to

sample data on input, TDI and to output data on output, TDO. The TMS input is used to direct the

TAP controller through its states. The basic boundary scan architecture is shown below.

Figure 20 – Boundary Scan Architecture

Boundary Scan

Control

TDI

TDO

Device Identification

Bypass

Instruction

and

Decode

TRSTB

TMS

TCK

Test

Access

Port

Controller

Mux

DFF

Select

Tri-state Enable

The boundary scan architecture consists of a TAP controller, an instruction register with instruction

decode, a bypass register, a device identification register and a boundary scan register. The TAP

PM7366-PI 데이터시트(PDF) 255 Page - PMC-Sierra, Inc