M68ICS08KX datasheet(61/77 Pages) MOTOROLA

61 / 77 page

User’s Manual

M68ICS08KX In-Circuit Simulator

Quick Start Hardware Configuration Guide

MOTOROLA

Quick Start Hardware Configuration Guide

NOTE:

Installation of a SOIC type MCU requires the use of the SOIC-to-DIP adapter

identified in Table 1-1 of this manual.

a. Place the pin tension arm of the KXICS DIP socket XU1 in the up

position.

b. Install the SOIC-to-DIP adapter into the DIP socket XU1. Be sure

that the pin 1 orientation of the adapter aligns with the pin 1 location

on the DIP socket (upper left pin of the DIP socket).

CAUTION:

The SOIC-to-DIP adapter may be confusing to install. It must be placed into the

DIP socket, XU1, with the hinged side of the SOIC shell aligned at the bottom

of the KXICS board. This positioning will place the SOIC-type MCU socket pin

1 in the upper left corner of the SOIC socket.

c. Place the pin tension arm of the KXICS DIP socket XU1 in the

down position to secure the pins of the adapter to the socket.

Open the hinged access door on the SOIC shell.

e. Install the SOIC-type MCU into the SOIC socket of the adapter. Be

sure that the pin 1 orientation of the silkscreened dot on the MCU

aligns with the pin 1 location on the SOIC socket (upper left pin of

the socket).

Close and secure the hinged access door on the SOIC shell.

Connect the board to the host PC.

Locate the 9-pin connector labeled J6 on the board. Using the cable

provided, connect it to a serial COM port on the host PC.

Apply power to the board.

Connect the 5-volt power supply to the round connector on the board, J2.

Plug the power supply into an ac power outlet, using one of the

country-specific adapters provided. (The KXICS green power LED on

the board should light when switch SW1 is in the ON position.)

B.3 Installing the Software

For instructions for installing the ICS08 software, refer to P&E Microcomputer

Systems, Inc., M68ICS08KX In-Circuit Simulator Operator’s Manual.

M68ICS08KX 데이터시트(PDF) 61 Page - Motorola, Inc