M68ICS08KX datasheet(21/77 Pages) MOTOROLA

21 / 77 page

Preparation and Installation

Hardware Preparation

M68ICS08KX In-Circuit Simulator

User’s Manual

MOTOROLA

Preparation and Installation

2.2.3 Installing an MCU on the KXICS

Either of two types of MCUs may be installed on the KXICS board, a DIP-type

or a SOIC-type.

2.2.3.1 DIP-type MCU

1. Place the pin tension arm of the KXICS DIP socket XU1 in the up

position.

2. Install the DIP type MCU into the DIP socket XU1. Be sure that the

pin 1 orientation of the silkscreened dot on the MCU aligns with the

pin 1 location on the DIP socket (upper left pin of the socket).

Table 2-1 KXICS Jumper Header Description

Jumper

Header

Type

(Factory

Default Shown

Description

Low Voltage

Select

Used to set power for the MCU to match various target voltages.(No

default)

Jumper on position 1 & 2:

3.3 V

Jumper on position 3 & 4:

3.0 V

Jumper on position 5 & 6:

2.7 V

Jumper on position 7 & 8

2.2 V

Jumper on position 9 & 10

2.0 V

Jumper on position 11 & 12:

ADJ

MCU Voltage

Select

Selects voltage powering MCU and related circuitry.

Jumper on position 1&2: Regulator Lo V as set by W1, is supplied by

MCU. Labeled LO V.

Jumper on position 3&2: Power supply, 5V Switched, is supplied by

board to MCU. Labeled 5V.

Target Clock

Select

Jumper on position 1&2: supplies KXICS,9.8304 MHz, clock, to MCU

and target via W4.

Jumper on position 3&2: disables Xtal clock output, which will affect the

power-up reset. Labeled 1.

PTB6 Select

Jumper on position 1&2: MCU’s internal clock is supplied to target

cable via PTB6.

Jumper on position 3&2: KXICS Xtal clock is supplied to MCU.

M68ICS08KX 데이터시트(PDF) 21 Page - Motorola, Inc

M68ICS08KX 데이터시트(HTML) 21 Page - Motorola, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77

데이터시트 다운로드

링크 URL