TDA7415CB datasheet(30/50 Pages) STMICROELECTRONICS

30 / 50 page

Description of the audio processor

TDA7415CB

30/50

The spectrum analyzer's input signal is either the mono-sum of the stereo MUXA-output or

alternatively a signal input at the SAin-pin. In order to have some influence on the visual

behavior in a given application the filter quality for all band-pass filters may be programmed

for two different qualities, with the higher filter quality creating a faster, more differentiating

optical response. If the spectrum analyzer is disabled both, the SAres- and the SAclk-pin

should be tied to ground.

Figure 21.

Spectrum analyzer block diagram

The microprocessor starts a read cycle with a negative going clock edge at the SAclk input.

On the following positive clock edges, the stored peak signal level of the band pass filters is

subsequently switched to SAout. Each analog output value is valid after the time tSAdel. A

reset of the sample capacitors is triggered by either pulling the SAres-pin low any time or by

setting-up the spectrum-analyzer for Auto-reset mode. Although not shown in Figure 22, for

the Auto-reset mode a reset is generated whenever SAclk remains high for the time tintres.

Note that a proper auto-reset requires the clock signal SAclk to be held at high potential and

that the reset is not repetitive. Once a reset was triggered, a new read-out cycle should not

be initiated before the time trepeat has passed. This allows sufficient settling of the filters.

Figure 22 illustrates the read cycle timing of the spectrum analyzer.

Figure 22.

Read cycle timing diagram

TDA7415CB 데이터시트(PDF) 30 Page - STMicroelectronics