SN260 datasheet(17/88 Pages) STMICROELECTRONICS

17 / 88 page

SN260

Functional description

17/88

The primary features of the MAC are:

●

CRC generation, appending, and checking

●

Hardware timers and interrupts to achieve the MAC symbol timing

●

Automatic preamble, and SFD pre-pended to a TX packet

●

Address recognition and packet filtering on received packets

●

Automatic acknowledgement transmission

●

Automatic transmission of packets from memory

●

Automatic transmission after backoff time if channel is clear (CCA)

●

Automatic acknowledgement checking

●

Time stamping of received and transmitted messages

●

Attaching packet information to received packets (LQI, RSSI, gain, time stamp, and

packet status)

●

IEEE 802.15.4-2003 timing and slotted/unslotted timing

5.4

Packet trace interface (PTI)

The SN260 integrates a true PHY-level PTI for effective network-level debugging. This two-

signal interface monitors all the PHY TX and RX packets (in a non-intrusive manner)

between the MAC and baseband modules. It is an asynchronous 500kbps interface and

cannot be used to inject packets into the PHY/MAC interface. The two signals from the

SN260 are the frame signal (PTI_EN) and the data signal (PTI_DATA). The PTI is supported

by InSight Desktop.

5.5

16-bit microprocessor

The SN260 integrates the XAP2b microprocessor developed by Cambridge Consultants

Ltd., making it a true network processor solution. The XAP2b is a 16-bit Harvard

architecture processor with separate program and data address spaces. The word width is

16 bits for both the program and data sides.

The standard XAP2 microprocessor and accompanying software tools have been enhanced

to create the XAP2b microprocessor used in the SN260. The XAP2b adds data-side byte

addressing support to the XAP2 allowing for more productive usage of RAM and optimized

code.

The XAP2b clock speed is 12MHz. When used with the EmberZNet stack, firmware is

loaded into Flash memory over the air or by a serial link using a built-in bootloader in a

reserved area of the Flash. Alternatively, firmware may be loaded via the SIF interface with

the assistance of RAM-based utility routines also loaded via SIF.

5.6

Embedded memory

The SN260 contains embedded Flash and RAM memory for firmware storage and

execution. In addition it partitions a portion of the Flash for simulated EEPROM and token

storage.

SN260 데이터시트(PDF) 17 Page - STMicroelectronics

SN260 데이터시트(HTML) 17 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88

데이터시트 다운로드

링크 URL