TMS320VC33 datasheet(44/59 Pages) TI2

44 / 59 page

TMS320VC33

DIGITAL SIGNAL PROCESSOR

SPRS087E -- FEBRUARY 1999 -- REVISED JANUARY 2004

POST OFFICE BOX 1443

• HOUSTON, TEXAS 77251--1443

interrupt-acknowledge timing

The IACK output goes active on the first half-cycle (HI rising) of the decode phase of the IACK instruction and

goes inactive at the first half-cycle (HI rising) of the read phase of the IACK instruction.

The following table defines the timing parameters for the IACK signal.

NOTE: The IACK instruction can be executed at anytime to signal an event using the IACK pin. The IACK

instruction is most often used within an interrupt routine to signal which interrupt has occurred. The IACK

instruction must be executed to generate the IACK pulse.

switching characteristics over recommended operating conditions for IACK (see Figure 30)

PARAMETER

VC33-120

VC33-150

UNIT

PARAMETER

MIN MAX

UNIT

td(H1H-IACKL)

Delay time, H1 high to IACK low

--1

td(H1H-IACKH)

Delay time, H1 high to IACK high

--1

IACK

ADDR

Data

Fetch IACK

Instruction

IACK Data

Read

Decode IACK

Instruction

td(H1H-IACKL)

td(H1H-IACKH)

Figure 30. Interrupt Acknowledge (IACK) Timing

TMS320VC33 데이터시트(PDF) 44 Page - Texas Instruments