| 전자부품 데이터시트 검색엔진 |
|
BQ25713 데이터시트(PDF) 48 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
BQ25713 데이터시트(HTML) 48 Page - Texas Instruments |
|
48 / 111 page ![]() Table 8-9. ChargeOption0 Register (I2C address = 00h) Field Descriptions (continued) BIT FIELD TYPE RESET DESCRIPTION 2 EN_LDO R/W 1b LDO Mode Enable When battery voltage is below minimum system voltage (REG0x0C()), the charger is in pre-charge with LDO mode enabled. 0b: Disable LDO mode, BATFET fully ON. Precharge current is set by battery pack internal resistor. 1b: Enable LDO mode, Precharge current is set by the ChargeCurrent register and clamped below 384 mA (2 cell – 4 cell, 1cell VBAT<3.0V) or 2A (1cell 3.0V<VBAT<3.6V). The system is regulated by the VSYS_MIN register. <default at POR> 1 EN_IIN_DPM R/W 1b IIN_DPM Enable Host writes this bit to enable IIN_DPM regulation loop. When the IIN_DPM is disabled by the charger (refer to IIN_DPM_AUTO_DISABLE), this bit goes LOW. 0b: IIN_DPM disabled 1b: IIN_DPM enabled <default at POR> 0 CHRG_INHIBIT R/W 0b Charge Inhibit When this bit is 0, battery charging will start with valid values in the ChargeVoltage() register and the ChargeCurrent register. 0b: Enable Charge <default at POR> 1b: Inhibit Charge BQ25730 SLUSE65A – FEBRUARY 2021 – REVISED JANUARY 2024 www.ti.com 48 Submit Document Feedback Copyright © 2024 Texas Instruments Incorporated Product Folder Links: BQ25730 |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |