MSP430 datasheet(42/96 Pages) TI2

42 / 96 page

MSP430G2533, MSP430G2433, MSP430G2333, MSP430G2233

MSP430G2403, MSP430G2303, MSP430G2203

SLAS734G – APRIL 2011 – REVISED APRIL 2016

www.ti.com

Submit Documentation Feedback

Product Folder Links: MSP430G2533 MSP430G2433 MSP430G2333 MSP430G2233 MSP430G2403 MSP430G2303

MSP430G2203

Detailed Description

6.8

Flash Memory

The flash memory can be programmed through the Spy-Bi-Wire/JTAG port or in-system by the CPU. The

CPU can perform single-byte and single-word writes to the flash memory. Features of the flash memory

include:

•

Flash memory has n segments of main memory and four segments of information memory (A to D) of

64 bytes each. Each segment in main memory is 512 bytes in size.

•

Segments 0 to n may be erased in one step, or each segment may be individually erased.

•

Segments A to D can be erased individually or as a group with segments 0 to n. Segments A to D are

also called information memory.

•

Segment A contains calibration data. After reset segment A is protected against programming and

erasing. It can be unlocked but care should be taken not to erase this segment if the device-specific

calibration data is required.

6.9

Peripherals

Peripherals are connected to the CPU through data, address, and control buses. The peripherals can be

managed using all instructions. For complete module descriptions, see the MSP430x2xx Family User's

Guide (SLAU144).

6.9.1

Oscillator and System Clock

The clock system is supported by the basic clock module that includes support for a 32768-Hz watch

crystal oscillator, an internal very-low-power low-frequency oscillator and an internal digitally controlled

oscillator (DCO). The basic clock module is designed to meet the requirements of both low system cost

and low power consumption. The internal DCO provides a fast turnon clock source and stabilizes in less

than 1 µs. The basic clock module provides the following clock signals:

•

Auxiliary clock (ACLK), sourced either from a 32768-Hz watch crystal or the internal LF oscillator.

•

Main clock (MCLK), the system clock used by the CPU.

•

Sub-Main clock (SMCLK), the subsystem clock used by the peripheral modules.

The DCO settings to calibrate the DCO output frequency are stored in the information memory segment A.

MSP430 데이터시트(PDF) 42 Page - Texas Instruments

MSP430 데이터시트(HTML) 42 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96

데이터시트 다운로드

링크 URL