IS25LE01G-RILA3-TY datasheet(40/186 Pages) ISSI

40 / 186 page

IS25LE01G

IS25WE01G

Integrated Silicon Solution, Inc.- www.issi.com

Rev. A6

01/14/2025

7. PROTECTION MODE

The device supports hardware and software write-protection mechanisms.

7.1 HARDWARE WRITE PROTECTION

The Write Protection (WP#) pin provides a hardware write protection method for BP3, BP2, BP1, BP0, SRWD, and

QE in the Status Register. Refer to the section 6.1 STATUS REGISTER.

Write inhibit voltage (VWI) is specified in the section 9.8 POWER-UP AND POWER-DOWN. All write sequence will

be ignored when Vcc drops to VWI.

Table 7.1 Hardware Write Protection on Status Register

SRWD

WP#

Status Register

Low

Writable

Low

Protected

High

Writable

High

Writable

Note: Before the execution of any program, erase or Write Status/Function Register instruction, the Write Enable Latch

(WEL) bit must be enabled by executing a Write Enable (WREN) instruction. If the WEL bit is not enabled, the

program, erase or write register instruction will be ignored.

7.2 SOFTWARE WRITE PROTECTION

The device also provides two kinds of software write protection feature. One is Block Protection by Block Protection

bits (BP3, BP2, BP1, BP0) and another is Advanced Sector/Block Protection (ASP). When Block Protection is

enabled (i.e., any BP3-

0 are set to “1”), Advanced Sector/Block Protection (ASP) can still be used to protect

sectors/blocks not protected by the Block Protection scheme. In the case that both ASP and Block Protection are

used on the same sector/block the logical OR of ASP and Block Protection related to the sector/block is used.

Warning: ASP and Block Protection should not be used concurrently. Use one or the other, but not both.

7.2.1 BLOCK PROTECTION BITS

The device provides a software write protection feature. The Block Protection bits (BP3, BP2, BP1, BP0) allow part

or the whole memory area to be write-protected. For details, see 6.1 Status Register.

IS25LE01G-RILA3-TY 데이터시트(PDF) 40 Page - Integrated Silicon Solution, Inc