NRF51822-CEAA-R7 datasheet(24/130 Pages) NORDIC

24 / 130 page

Page 24

nRF51822 Product Specification v3.3

3.4

Power management (POWER)

3.4.1

Power supply

nRF51 supports three different power supply alternatives:

• Internal LDO setup

•DC/DC converter setup

• Low voltage mode setup

See Table 20 on page 39 for the voltage range on the different alternatives. See Chapter 11 “Reference

circuitry” on page 79 for details on the schematic used for the different power supply alternatives.

3.4.1.1

Internal LDO setup

In internal LDO mode the DC/DC converter is bypassed (disabled) and the system power is generated

directly from the supply voltage VDD. This mode could be used as the only option or in combination with

the DC/DC converter setup. See DC/DC converter section for more details.

3.4.1.2

DC/DC converter setup

The nRF51 DC/DC buck converter transforms battery voltage to lower internal voltage with minimal power

loss. The converted voltage is then available for the linear regulator input. The DC/DC converter can be

disabled when the supply voltage drops to the lower limit of the voltage range so the LDO can be used for

low supply voltages. When enabled, the DC/DC converter operation is automatically suspended between

radio events when only the low current regulator is needed internally.

This feature is particularly useful for applications using battery technologies with nominal cell voltages

higher than the minimum supply voltage with DC/DC enabled. The reduction in supply voltage level from a

high voltage to a low voltage reduces the peak power drain from the battery. Used with a 3 V coin-cell

battery, the peak current drawn from the battery is reduced by approximately 25%.

3.4.1.3

Low voltage mode setup

Devices can be used in low voltage mode where a steady 1.8 V supply is available externally.

NRF51822-CEAA-R7 데이터시트(PDF) 24 Page - Nordic Semiconductor