TDA2SA datasheet(77/427 Pages) TI2

77 / 427 page

Terminal Configuration and Functions

Submit Documentation Feedback

Product Folder Links: TDA2SX TDA2SG TDA2SA TDA2HG TDA2HV TDA2HF TDA2LF

TDA2SX, TDA2SG, TDA2SA

TDA2HG, TDA2HV, TDA2HF, TDA2LF

www.ti.com

SPRS951F – DECEMBER 2015 – REVISED MAY 2019

4.3

Multiplexing Characteristics

Table 4-3 describes the device multiplexing (no characteristics are available in this table).

NOTE

This table doesn't take into account subsystem multiplexing signals. Subsystem multiplexing signals are described in Section 4.4, Signal

Descriptions.

NOTE

For more information, see the Control Module / Control Module Functional Description / PAD Functional Multiplexing and Configuration

section of the Device TRM.

NOTE

Configuring two pins to the same input signal is not supported as it can yield unexpected results. This can be easily prevented with the

proper software configuration (Hi-Z mode is not an input signal).

NOTE

When a pad is set into a multiplexing mode which is not defined by pin multiplexing, that pad’s behavior is undefined. This should be

avoided.

CAUTION

The I/O timings provided in Section 7 Timing Requirements and Switching Characteristics are valid only if signals within

a single IOSET are used. The IOSETs are defined in the corresponding tables.

Table 4-3. Multiplexing Characteristics

ADDRESS

BALL

NUMBER

MUXMODE FIELD SETTINGS (CTRL_CORE_PAD_*[3:0])

P25

ddr2_a6

Y23

ddr1_d26

Y19

ddr1_d21

AE15

xi_osc0

AH24

ddr1_nck

TDA2SA 데이터시트(PDF) 77 Page - Texas Instruments