AD4083BBCZ datasheet(49/94 Pages) AD

49 / 94 page

Data Sheet

AD4083

DIGITAL INTERFACE

analog.com

Rev. 0 | 49 of 94

LVDS Data Transfer Latency

Where the user is concerned in knowing the overall latency from

when an individual ADC conversion is initiated to the time when

the LSB has reached the host controller, it is important to consider

the data transfer latency. The total latency observed is the sum of

the ADC latency and the data transfer latency, in this case, the

LVDS_CNV_CLK_CNT is set to achieve minimum ADC latency.

Additional clock cycles more than the minimum required incur

additional LVDS clock cycles of latency to the overall latency, as is

shown in Figure 80.

The data transfer latency on the LVDS interface depends on the

following parameters:

►

LVDS clock period, tCLK

►

Number of active LVDS lanes, NLANES

►

Number of bits to be read, NBITS

Calculate the latency as follows:

Data

Transfer Latency= NBITSNLANES×tCLK

For applications that require extremely low latencies, note that as

the data is transferred MSB to LSB in both single and dual lane

modes, and that there is no requirement to fully read a result from

the interface, the data transfer latency can be reduced for lower

resolution results (that is, NBITS can be chosen to be smaller than

the maximum 16 bits available).

Figure 80. LVDS Data Transfer Latency

AD4083BBCZ 데이터시트(PDF) 49 Page - Analog Devices