STW81103 datasheet(24/53 Pages) STMICROELECTRONICS

24 / 53 page

Circuit description

STW81103

24/53

The SERCAL bit should be set to “1” at each division ratio change. The VCO calibration

procedure takes approximately 7 periods of the PFD frequency.

The maximum allowed FPFD to perform the calibration process is 1 MHz. When using a

higher FPFD, follow the steps below:

Calibrate the VCO at the desired frequency with an FPFD less than 1 MHz.

Set the ratio of the A, B and R dividers for the desired FPFD.

VCO calibration auto-restart feature

The VCO calibration auto-restart feature, once activated, allows to restart the calibration

procedure when the lock detector reports that the PLL has moved to an unlock condition

(trigger on ‘1’ to ‘0’ transition of lock detector signal).

This situation could happen if the device experiences a significant temperature variation.

Once programmed at the initial temperature T0 inside the operating temperature range

(-40 °C to +85 °C), the synthesizer is able to maintain the lock status only if the temperature

drift (in either direction) is within the limit specified by the

ΔTLK parameter, provided that the

final temperature T1 is still inside the nominal range.

Each VCO featured by STW81103 has its specific

ΔTLK parameter reported in Table 5, that

is typically lower than the maximum allowable drift (

ΔTMAX=125; from -40 °C to +85 °C and

vice versa).

By enabling the VCO calibration auto-restart feature (through the CAL_AUTOSTART_EN

bit), the part will be able to select again the proper VCO frequency sub-range if the

temperature drift exceeds the

ΔTLK limit, without any external user command.

5.8.3

VCO voltage amplitude control

The voltage swing of the VCOs can be adjusted over four levels by means of two dedicated

programming bits (PLL_A1 and PLL_A0). Higher amplitudes provide best phase noise,

whereas lower amplitudes save power.

Table 8 gives the voltage swing level expected on the resonator nodes, the current

consumption, and the phase noise at 1 MHz.

Table 8.

VCO A performances versus amplitude setting (Freq = 2.8 GHz)

PLL_A[1:0]

Differential

voltage swing (Vp)

Current

consumption (mA)

PN @1 MHz (dBc/Hz)

1.1

-126

1.3

-127

1.9

-130

2.1

-131

STW81103 데이터시트(PDF) 24 Page - STMicroelectronics

STW81103 데이터시트(HTML) 24 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

데이터시트 다운로드

링크 URL