STW81103 datasheet(27/53 Pages) STMICROELECTRONICS

27 / 53 page

STW81103

I2C bus interface

27/53

I2C bus interface

The I2C bus interface is selected by hardware connection of pin #21 (DBUS_SEL) to 0 V.

Data is transmitted from microprocessor to the STW81103 through the 2-wire (SDA and

SCL) I2C bus interface. The STW81103 is always a slave device.

The I2C bus protocol defines any device that sends data on the bus as a transmitter, and

any device that reads the data as a receiver. The device controlling the data transfer is the

master, and the others are slaves. The master always initiates the transfer and provides the

serial clock for synchronization.

The STW81103 I2C bus supports Fast Mode operation (clock frequency up to 1MHz).

6.1

General features

6.1.1

Data validity

Data changes on the SDA line must only occur when the SCL is low. SDA transitions while

the clock is high are used to identify a START or STOP condition.

Figure 20.

Data validity

6.1.2

START and STOP conditions

START condition

A START condition is identified by a transition of the data bus SDA from high to low while the

clock signal SCL is stable in the high state. A START condition must precede any data

transfer command.

STOP condition

A STOP condition is identified by a transition of the data bus SDA from low to high while the

clock signal SCL is stable in the high state. A STOP condition terminates communications

between the STW81103 and the bus master.

SDA

SCL

Data line

Change

Stable data

data

Valid

allowed

STW81103 데이터시트(PDF) 27 Page - STMicroelectronics