STA328 datasheet(45/57 Pages) STMICROELECTRONICS

45 / 57 page

STA328

User programmable processing

45/57

User programmable processing

7.1

EQ - biquad equation

The biquads use the equation that follows. This is diagrammed in Figure 18 below.

Y[n] = 2(b0/2)X[n] + 2(b1/2)X[n - 1] + b2X[n - 2] - 2(a1/2)Y[n - 1] - a2Y[n - 2]

= b0X[n] + b1X[n - 1] + b2X[n - 2] - a1Y[n - 1] - a2Y[n - 2]

where Y[n] represents the output and X[n] represents the input. Multipliers are 28-bit signed

fractional multipliers, with coefficient values in the range of 0x800000 (-1) to 0x7FFFFF

(0.9999998808).

Coefficients stored in the user defined coefficient RAM are referenced in the following

manner:

CxHy0 = b1/2

CxHy1 = b2

CxHy2 = -a1/2

CxHy3 = -a2

CxHy4 = b0/2

The x represents the channel and the y the biquad number. For example C3H41 is the b0/2

coefficient in the fourth biquad for channel 3

Figure 18.

Biquad filter

7.2

Pre-scale

The pre-scale block which precedes the first biquad is used for attenuation when filters are

designed that boost frequencies above 0 dBFS. This is a single 28-bit signed multiplier, with

0x800000 = -1 and 0x7FFFFF = 0.9999998808. By default, all pre-scale factors are set to

0x7FFFFF.

7.3

Post-scale

The STA328 provides one additional multiplication after the last interpolation stage and

before the distortion compensation on each channel. This is a 24-bit signed fractional

multiplier. The scale factor for this multiplier is loaded into RAM using the same I2C registers

as the biquad coefficients and the mix. All channels can use the same settings as channel 1

by setting the post-scale link bit.

-a2

-a1 /2

b1 /2

b0 /2

Z -1

STA328 데이터시트(PDF) 45 Page - STMicroelectronics