6

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

Air compressors used with the tool must comply with the appropriate

European Community Safety Directives.

The air hose must be rated at least 150% of the maximum operating pressure of

the tool.

For optimum performance it is recommended that a 3/8” ID airline hose is

used.

A build-up of moisture or oil in the air compressor will accelerate wear and

corrosion in the air tool. Ensure any moisture is drained from the compressor

daily and the inlet filter is kept clean.

If an unusually long air hose is required, (over 8 metres), the line pressure or the

hose inside diameter may need to be increased to maintain air pressure at the

tool.

Never exceed the maximum operating pressure for the air tool. It is

recommended that air pressure to this tool does not exceed 90 psi (6.2 Bar) at

the air tool when running. Higher pressures and dirty air will shorten the life of

the tool due to faster wear and is a possible safety hazard.

Check hoses for wear or damage before use.

OVERVIEW

NO DESCRIPTION

NO DESCRIPTION

1

Direction Control

4

Airline Inlet

2

1/2” Square Drive

5

Airline adaptor

3Trigger