9

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

DISCONNECTING THE AIR SUPPLY

1. DO NOT disconnect the air hose until the supply is isolated at a shut-off

valve.

2. Once the pressure has been isolated, disconnect the air supply hose from

the air tool.

3. Shut down the compressor at the end of the work session and drain daily as

recommended.

STORAGE

If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of

CLARKE air line oil into the air inlet, and run the tool for 5 seconds in order to

lubricate the internal parts.

Store the tool safely in its box in a dry, secure environment. When storing,

replace the blanking plug on the airline inlet once the airline has been

disconnected.

Avoid storing the air tool where the temperature is below 0oC.