| 전자부품 데이터시트 검색엔진 |
|
LAN9312 데이터시트(PDF) 28 Page - SMSC Corporation |
|
|
|||||||||||||||||||||||||||||
LAN9312 데이터시트(HTML) 28 Page - SMSC Corporation |
|
28 / 458 page ![]() High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface Datasheet Revision 1.2 (04-08-08) 28 SMSC LAN9312 DATASHEET 3.2 Pin Descriptions This section contains the descriptions of the LAN9312 pins. The pin descriptions have been broken into functional groups as follows: LAN Port 1 Pins LAN Port 2 Pins LAN Port 1 & 2 Power and Common Pins Host Bus Interface Pins EEPROM Pins Dedicated Configuration Strap Pins Miscellaneous Pins PLL Pins Core and I/O Power and Ground Pins No-Connect Pins Note: A list of buffer type definitions is provided in Section 1.2, "Buffer Types," on page 18. Table 3.1 LAN Port 1 Pins PIN NAME SYMBOL BUFFER TYPE DESCRIPTION 89-92 Port 1 LED Indicators nP1LED[3:0] OD12 LED Indicators: When configured as LED outputs via the LED Configuration Register (LED_CFG), these pins are open-drain, active low outputs and the pull-ups and input buffers are disabled. The functionality of each pin is determined via the LED_CFG[9:8] bits. General Purpose I/O Data GPIO[3:0] IS/O12/ OD12 (PU) General Purpose I/O Data: When configured as GPIO via the LED Configuration Register (LED_CFG), these general purpose signals are fully programmable as either push-pull outputs, open-drain outputs or Schmitt-triggered inputs by writing the General Purpose I/O Configuration Register (GPIO_CFG) and General Purpose I/O Data & Direction Register (GPIO_DATA_DIR). The pull-ups are enabled in GPIO mode. The input buffers are disabled when set as an output. Note: See Chapter 13, "GPIO/LED Controller," on page 162 for additional details. 110 Port 1 Ethernet TX Negative TXN1 AIO Ethernet TX Negative: Negative output of Port 1 Ethernet transmitter. See Note 3.1 for additional information. 111 Port 1 Ethernet TX Positive TXP1 AIO Ethernet TX Positive: Positive output of Port 1 Ethernet transmitter. See Note 3.1 for additional information. 115 Port 1 Ethernet RX Negative RXN1 AIO Ethernet RX Negative: Negative input of Port 1 Ethernet receiver. See Note 3.1 for additional information. 116 Port 1 Ethernet RX Positive RXP1 AIO Ethernet RX Positive: Positive input of Port 1 Ethernet receiver. See Note 3.1 for additional information. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |