9

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

3. Lift up the Chain Stop and

place the chain in the Sliding

Guide, as shown.

4. Lower the Chain Stop so that

it is positioned on the tooth

(blade) you want to start

with, using the adjustment

knob and locking nut to

position the Chain Stop as

required.

5. Loosen the Lock Wheel to

allow the entire housing to

turn. Rotate the housing to

match the degree of angle

you need on the Angle

Gauge.

NOTE: Chains come in various sizes with varying degrees of sharpening

angles. Check with the chain manufacturers manual to determine what

degree you need to sharpen at.

6. Once the degree is set, tighten the Lock Wheel.

7. Lower the Top Housing so that the Grinding Wheel skims the chain tooth.

8. Hold it at that position while

you adjust the Depth Lock

Stop so that the Grinding

Wheel will only go down to

that point.

9. Depending on the amount of

material you wish to remove,

tighten or loosen the Depth

Lock Stop and set the Lock

Nut.

NOTE: Once the Depth Lock

Stop is set, fully

tighten the Lock Nut.