14

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

CLEANING AND MAINTENANCE

1. Keep the tool clean and free of dust, metal debris and dirt.

NOTE: NEVER clean the tool with any flammable liquid.

2. Check the grinding wheel before each use to make sure it isn’t damaged. DO NOT

use a grinding wheel if it is chipped, cracked or worn. You can check if the wheel

has cracks not visible to the human eye by hanging it up by the central hole and

tapping it with a non metallic object (ie a screwdriver handle). If it is in a good

condition it will produce a metallic sound. A dull sound indicates a crack or break.

3. Replace the grinding wheel when it grinds down to a diameter of 3 inches/7.62cm.

• Replacement discs are available from your CLARKE dealer: part number

(3402079).

MOUNTING A GRINDING WHEEL

1. Turn off the sharpener and

remove the power cable

from the power socket.

2. Lay the sharpener on its

side.

3. Remove the three screws

that are holding the Grinding

Wheel Cover and set aside.

Remove the Grinding Wheel

Cover.

WARNING: BEFORE STARTING ANY CLEANING OR MAINTENANCE

PROCEDURES, DISCONNECT THE PLUG FROM MAINS SUPPLY.

WARNING: NEVER OPERATE THE SHARPENER WITHOUT THE

GRINDING WHEEL COVER IN PLACE.