M16CSLASH29 datasheet(90/499 Pages) RENESAS

90 / 499 page

7. Clock Generation Circuit

page 66

7.7 System Clock Protective Function

When the main clock is selected for the CPU clock source, this function protects the clock from modifica-

tions in order to prevent the CPU clock from becoming halted by run-away.

If the PM21 bit in the PM2 register is set to 1 (clock modification disabled), the following bits are protected

against writes:

• Bits CM02, CM05, and CM07 in CM0 register

• Bits CM10 and CM11 in CM1 register

• CM20 bit in CM2 register

• All bits in the PLC0 register

Before the system clock protective function can be used, the following register settings must be made while

the CM05 bit in the CM0 register is 0 (main clock oscillating) and CM07 bit is 0 (main clock selected for the

CPU clock source):

(1) Set the PRC1 bit in the PRCR register to 1 (enable writes to PM2 register).

(2) Set the PM21 bit in the PM2 register to 1 (disable clock modification).

(3) Set the PRC1 bit in the PRCR register to 0 (disable writes to PM2 register).

Do not execute the WAIT instruction when the PM21 bit is 1.

7.8 Oscillation Stop and Re-oscillation Detect Function

The oscillation stop and re-oscillation detect function detects the re-oscillation after stop of main clock

oscillation circuit. When the oscillation stop and re-oscillation detection occurs, the oscillation stop detect

function is reset or oscillation stop and re-oscillation detection interrupt is generated, depending on the

CM27 bit set in the CM2 register. The oscillation stop detect function is enabled or disabled by the CM20 bit

in the CM2 register. Table 7.8 lists a specification overview of the oscillation stop and re-oscillation detect

function.

Table 7.8 Specification Overview of Oscillation Stop and Re-oscillation Detect Function

Item

Specification

Oscillation stop detectable clock and

f(XIN) ≥ 2 MHz

frequency bandwidth

Enabling condition for oscillation stop, Set CM20 bit to 1(enable)

re-oscillation detection function

Operation at oscillation stop,

•Reset occurs (when CM27 bit =0)

re-oscillation detection

•Oscillation stop, re-oscillation detection interrupt occurs(when CM27 bit =1)

M16C/29 데이터시트(PDF) 90 Page - Renesas Technology Corp