HD64F2149YV datasheet(702/1075 Pages) RENESAS

702 / 1075 page

Section 20 A/D Converter

Rev. 3.00 Jan 18, 2006 page 674 of 1044

REJ09B0280-0300

20.4.2

Scan Mode (SCAN = 1)

Scan mode is useful for monitoring analog inputs in a group of one or more channels. When the

ADST bit is set to 1 by software, or by timer or external trigger input, A/D conversion starts on the

first channel in the group (AN0 when CH2 = 0; AN4 when CH2 = 1). When two or more channels

are selected, after conversion of the first channel ends, conversion of the second channel (AN1 or

AN5) starts immediately. A/D conversion continues cyclically on the selected channels until the

ADST bit is cleared to 0. The conversion results are transferred for storage into the ADDR

registers corresponding to the channels.

When the operating mode or analog input channel must be changed during analog conversion, to

prevent incorrect operation, first clear the ADST bit to 0 in ADCSR to halt A/D conversion. After

making the necessary changes, set the ADST bit to 1 to start A/D conversion again. The ADST bit

can be set at the same time as the operating mode or input channel is changed.

Typical operations when three channels (AN0 to AN2) are selected in scan mode are described

next. Figure 20.4 shows a timing diagram for this example.

1. Scan mode is selected (SCAN = 1), scan group 0 is selected (CH2 = 0), analog input channels

AN0 to AN2 are selected (CH1 = 1, CH0 = 0), and A/D conversion is started (ADST = 1)

2. When A/D conversion of the first channel (AN0) is completed, the result is transferred to

ADDRA. Next, conversion of the second channel (AN1) starts automatically.

3. Conversion proceeds in the same way through the third channel (AN2).

4. When conversion of all the selected channels (AN0 to AN2) is completed, the ADF flag is set

to 1 and conversion of the first channel (AN0) starts again. If the ADIE bit is set to 1 at this

time, an ADI interrupt is requested after A/D conversion ends.

5. Steps 2 to 4 are repeated as long as the ADST bit remains set to 1. When the ADST bit is

cleared to 0, A/D conversion stops. After that, if the ADST bit is set to 1, A/D conversion

starts again from the first channel (AN0).

HD64F2149YV 데이터시트(PDF) 702 Page - Renesas Technology Corp