H8SXSLASH1663M datasheet(148/1504 Pages) RENESAS

148 / 1504 page

Section 6 Exception Handling

Rev. 2.00 Sep. 24, 2008 Page 116 of 1468

REJ09B0412-0200

Table 6.3

Calculation Method of Exception Handling Vector Table Address

Exception Source

Calculation Method of Vector Table Address

Reset, CPU address error

Vector table address = (vector table address offset)

Other than above

Vector table address = VBR

+ (vector table address offset)

[Legend]

VBR: Vector base register

Vector table address offset: See table 6.2.

6.3

Reset

A reset has priority over any other exception. When the

RES pin goes low, all processing halts and

this LSI enters the reset state. To ensure that this LSI is reset, hold the

RES pin low for at least 20

ms with the

STBY pin driven high when the power is turned on. When operation is in progress,

hold the

RES pin low for at least 20 states.

The chip can also be reset by the overflow that is generated in watchdog timer mode of the

watchdog timer. For details, see section 28, Power-Down Modes, and section 18, Watchdog Timer

(WDT).

A reset initializes the internal state of the CPU and the registers of the on-chip peripheral modules.

The interrupt control mode is 0 immediately after a reset.

6.3.1

Reset Exception Handling

When the

RES pin goes high after being held low for the necessary time, this LSI starts reset

exception handling as follows:

1. The internal state of the CPU and the registers of the on-chip peripheral modules are

initialized, VBR is cleared to H'00000000, the T bit is cleared to 0 in EXR, and the I bits are

set to 1 in EXR and CCR.

2. The reset exception handling vector address is read and transferred to the PC, and program

execution starts from the address indicated by the PC.

Figures 6.1 and 6.2 show examples of the reset sequence.

H8SX/1663M 데이터시트(PDF) 148 Page - Renesas Technology Corp