M32CSLASH86 datasheet(487/505 Pages) RENESAS

487 / 505 page

Page 464

)

(

27.9 Timer

27.9.1 Timers A and B

Timers stop after reset. Set the TAiS(i=0 to 4) bit or TBjS(j=0 to 5) bit in the TABSR register or TBSR

The following registers and bits must be set while the TAiS bit or TBjS bit is set to "0" (stops counting).

• TAiMR, TBjMR register

• TAi, TBj register

• UDF register

• TAZIE, TA0TGL, TA0TGH bits in the ONSF register

• TRGSR register

27.9.2 Timer A

The TA1OUT, TA2OUT and TA4OUT pins are placed in high-impedance states when a low-level ("L") signal

_______

is applied to the NMI pin while the INV03 and INV02 bits in the INVC0 register are set to "112" (forced

_______

cutoff of the three-phase output by an "L" signal applied to the NMI pin).

27.9.2.1 Timer A (Timer Mode)

• The TAiS bit (i=0 to 4) in the TABSR register is set to "0" (stops counting) after reset. Set the TAiS

bit to "1" (starts counting) after selecting an operating mode and setting the TAi register.

• The TAi register indicates the counter value during counting at any given time. However, the

counter is "FFFF16" when reloading. The setting value can be read after setting the TAi register

while the counter stops and before the counter starts counting.

27.9.2.2 Timer A (Event Counter Mode)

• The TAiS (i=0 to 4) bit in the TABSR register is set to "0" (stops counting) after reset. Set the TAiS

bit to "1" (starts counting) after selecting an operating mode and setting the TAi register.

• The TAi register indicates the counter values during counting at any given time. However, the

counter will be "FFFF16" during underflow and "000016" during overflow, when reloading. The set-

ting value can be read after setting the TAi register while the counter stops and before the counter

starts counting.

27. Precautions (Timer)

M32C/86 데이터시트(PDF) 487 Page - Renesas Technology Corp