LPC2158 datasheet(19/45 Pages) PHILIPS

19 / 45 page

LPC2157_2158_2

Product data sheet

Rev. 02 — 9 February 2009

19 of 45

NXP Semiconductors

LPC2157/2158

Single-chip 16-bit/32-bit microcontrollers

The LPC2158 is equipped with a USB device controller that enables 12 Mbit/s data

exchange with a USB host controller. It consists of a register interface, serial interface

engine, endpoint buffer memory and DMA controller. The serial interface engine decodes

the USB data stream and writes data to the appropriate end point buffer memory. The

status of a completed USB transfer or error condition is indicated via status registers. An

interrupt is also generated if enabled.

A DMA controller can transfer data between an endpoint buffer and the USB RAM.

6.10.1 Features

• Fully compliant with USB 2.0 Full-speed speciﬁcation.

• Supports 32 physical (16 logical) endpoints.

• Supports control, bulk, interrupt and isochronous endpoints.

• Scalable realization of endpoints at run time.

• Endpoint maximum packet size selection (up to USB maximum speciﬁcation) by

software at run time.

• RAM message buffer size based on endpoint realization and maximum packet size.

• Supports SoftConnect and GoodLink LED indicator. These two functions are sharing

one pin.

• Supports bus-powered capability with low suspend current.

• Supports DMA transfer on all non-control endpoints.

• One duplex DMA channel serves all endpoints.

• Allows dynamic switching between CPU controlled and DMA modes.

• Double buffer implementation for bulk and isochronous endpoints.

6.11 UARTs

The LPC2157/2158 each contain two UARTs. In addition to standard transmit and receive

data lines, the UART1 also provides a full modem control handshake interface.

Compared to previous LPC2000 microcontrollers, UARTs in LPC2157/2158 introduce a

fractional baud rate generator for both UARTs, enabling these microcontrollers to achieve

standard baud rates such as 115200 Bd with any crystal frequency above 2 MHz. In

addition, auto-CTS/RTS ﬂow-control functions are fully implemented in hardware.

6.11.1 Features

• 16 B Receive and Transmit FIFOs.

• Register locations conform to 16C550 industry standard.

• Receiver FIFO trigger points at 1 B, 4 B, 8 B and 14 B

• Built-in fractional baud rate generator covering wide range of baud rates without a

need for external crystals of particular values.

• Transmission FIFO control enables implementation of software (XON/XOFF) ﬂow

control on both UARTs.

• LPC2158 UART1 equipped with standard modem interface signals. This module also

provides full support for hardware ﬂow control (auto-CTS/RTS).

LPC2158 데이터시트(PDF) 19 Page - NXP Semiconductors

LPC2158 데이터시트(HTML) 19 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

데이터시트 다운로드

링크 URL