25AA040AX-ESLASHMS datasheet(10/30 Pages) MICROCHIP

10 / 30 page

25AA040A/25LC040A

DS21827F-page 10

2.5

Read Status Register Instruction

(RDSR)

The Read Status Register instruction (RDSR) provides

access to the STATUS register. See Figure 2-6 for the

RDSR

timing sequence. The STATUS register may be

read at any time, even during a write cycle. The

STATUS register is formatted as follows:

TABLE 2-2:

STATUS REGISTER

The Write-In-Process (WIP) bit indicates whether the

25XX040A is busy with a write operation. When set to

a ‘1’, a write is in progress, when set to a ‘0’, no write

is in progress. This bit is read-only.

The Write Enable Latch (WEL) bit indicates the status

of the write enable latch and is read-only. When set to

a ‘1’, the latch allows writes to the array, when set to a

‘0’, the latch prohibits writes to the array. The state of

this bit can always be updated via the WREN or WRDI

commands regardless of the state of write protection

on the STATUS register. These commands are shown

in Figure 2-4 and Figure 2-5.

The Block Protection (BP0 and BP1) bits indicate

which blocks are currently write-protected. These bits

are set by the user issuing the WRSR instruction, which

is shown in Figure 2-7. These bits are nonvolatile and

are described in more detail in Table 2-3.

FIGURE 2-6:

READ STATUS REGISTER TIMING SEQUENCE (RDSR)

654

–

–––

W/R

XXX

BP1

BP0

WEL

WIP

W/R = writable/readable. R = read-only.

1011

12131415

Instruction

Data from STATUS Register

High-impedance

SCK

25AA040AX-E/MS 데이터시트(PDF) 10 Page - Microchip Technology

25AA040AX-E/MS 데이터시트(HTML) 10 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

데이터시트 다운로드

링크 URL