ATmega165 datasheet(188/336 Pages) ATMEL

188 / 336 page

188

ATmega165/V

2573G–AVR–07/09

Analog Comparator

Multiplexed Input

It is possible to select any of the ADC7..0 pins to replace the negative input to the Ana-

log Comparator. The ADC multiplexer is used to select this input, and consequently, the

ADC must be switched off to utilize this feature. If the Analog Comparator Multiplexer

Enable bit (ACME in ADCSRB) is set and the ADC is switched off (ADEN in ADCSRA is

zero), MUX2..0 in ADMUX select the input pin to replace the negative input to the Ana-

log Comparator, as shown in Table 79. If ACME is cleared or ADEN is set, AIN1 is

applied to the negative input to the Analog Comparator.

Digital Input Disable Register

1 – DIDR1

• Bit 1, 0 – AIN1D, AIN0D: AIN1, AIN0 Digital Input Disable

When this bit is written logic one, the digital input buffer on the AIN1/0 pin is disabled.

The corresponding PIN Register bit will always read as zero when this bit is set. When

an analog signal is applied to the AIN1/0 pin and the digital input from this pin is not

needed, this bit should be written logic one to reduce power consumption in the digital

input buffer.

Table 79. Analog Comparator Multiplexed Input

ACME

ADEN

MUX2..0

Analog Comparator Negative Input

xxx

AIN1

xxx

AIN1

000

ADC0

001

ADC1

010

ADC2

011

ADC3

100

ADC4

101

ADC5

110

ADC6

111

ADC7

Bit

7654

321

–

AIN1D

AIN0D

DIDR1

Read/Write

RRRR

R/W

Initial Value

0000

000

ATmega165 데이터시트(PDF) 188 Page - ATMEL Corporation

ATmega165 데이터시트(HTML) 188 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL