ATtiny88 datasheet(92/266 Pages) ATMEL

92 / 266 page

8008C–AVR–03/09

ATtiny48/88

Using the Input Capture unit in any mode of operation when the TOP value (resolution) is

actively changed during operation, is not recommended.

Measurement of an external signal’s duty cycle requires that the trigger edge is changed after

each capture. Changing the edge sensing must be done as early as possible after the ICR1

cleared by software (writing a logical one to the I/O bit location). For measuring frequency only,

the clearing of the ICF1 Flag is not required (if an interrupt handler is used).

12.7

Output Compare Units

The 16-bit comparator continuously compares TCNT1 with the Output Compare Register

(OCR1x). If TCNT equals OCR1x the comparator signals a match. A match will set the Output

Compare Flag (OCF1x) at the next timer clock cycle. If enabled (OCIE1x = 1), the Output Com-

pare Flag generates an Output Compare interrupt. The OCF1x Flag is automatically cleared

when the interrupt is executed. Alternatively the OCF1x Flag can be cleared by software by writ-

ing a logical one to its I/O bit location. The Waveform Generator uses the match signal to

generate an output according to operating mode set by the Waveform Generation mode

(WGM13:0) bits and Compare Output mode (COM1x1:0) bits. The TOP and BOTTOM signals

are used by the Waveform Generator for handling the special cases of the extreme values in

some modes of operation (See “Modes of Operation” on page 95.)

A special feature of Output Compare unit A allows it to define the Timer/Counter TOP value (i.e.,

counter resolution). In addition to the counter resolution, the TOP value defines the period time

for waveforms generated by the Waveform Generator.

Figure 12-4 shows a block diagram of the Output Compare unit. The small “n” in the register and

bit names indicates the device number (n = 1 for Timer/Counter 1), and the “x” indicates Output

Compare unit (A/B). The elements of the block diagram that are not directly a part of the Output

Compare unit are gray shaded.

Figure 12-4. Output Compare Unit, Block Diagram

OCFnx (Int.Req.)

= (16-bit Comparator )

OCRnx Buffer (16-bit Register)

OCRnxH Buf. (8-bit)

OCnx

TEMP (8-bit)

DATA BUS (8-bit)

OCRnxL Buf. (8-bit)

TCNTn (16-bit Counter)

TCNTnH (8-bit)

TCNTnL (8-bit)

COMnx1:0

WGMn3:0

OCRnx (16-bit Register)

OCRnxH (8-bit)

OCRnxL (8-bit)

Waveform Generator

TOP

BOTTOM

ATtiny88 데이터시트(PDF) 92 Page - ATMEL Corporation

ATtiny88 데이터시트(HTML) 92 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL