 |
전자부품 데이터시트 검색엔진 |
|
|
전자부품 데이터시트 검색엔진 |
|
ATtiny88 데이터시트(PDF) 166 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
ATtiny88 데이터시트(HTML) 166 Page - ATMEL Corporation |
|
|
166 / 266 page  166 8008C–AVR–03/09 ATtiny48/88 Figure 17-8. Analog Input Circuitry Note: The capacitor in the figure depicts the total capacitance, including the sample/hold capacitor and any stray or parasitic capacitance inside the device. The value given is worst case. 17.9 Analog Noise Canceling Techniques Digital circuitry inside and outside the device generates EMI which might affect the accuracy of analog measurements. When conversion accuracy is critical, the noise level can be reduced by applying the following techniques: • Keep analog signal paths as short as possible. • Make sure analog tracks run over the analog ground plane. • Keep analog tracks well away from high-speed switching digital tracks. • If any port pin is used as a digital output, it mustn’t switch while a conversion is in progress. • The analog supply voltage pin (AV CC) should be connected to the digital supply voltage pin (V CC) via an LC network as shown in Figure 17-9. Figure 17-9. ADC Power Connections ADCn IIH 1..100 k Ohm CS/H= 14 pF VCC/2 IIL PC1 (ADC1) PC0 (ADC0) PA1 (ADC7) GND PC7 AVCC PA0 (ADC6) PB5 VCC |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Korean ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
