ATmega325P datasheet(228/364 Pages) ATMEL

228 / 364 page

228

8023F–AVR–07/09

ATmega325P/3250P

The JTAG programming capability supports:

• Flash programming and verifying.

• EEPROM programming and verifying.

• Fuse programming and verifying.

• Lock bit programming and verifying.

The Lock bit security is exactly as in parallel programming mode. If the Lock bits LB1 or LB2 are

programmed, the OCDEN Fuse cannot be programmed unless first doing a chip erase. This is a

security feature that ensures no back-door exists for reading out the content of a secured

device.

The details on programming through the JTAG interface and programming specific JTAG

instructions are given in the section ”Programming via the JTAG Interface” on page 291.

22.9

Bibliography

For more information about general Boundary-scan, the following literature can be consulted:

• IEEE: IEEE Std. 1149.1-1990. IEEE Standard Test Access Port and Boundary-scan

Architecture, IEEE, 1993.

Colin Maunder: The Board Designers Guide to Testable Logic Circuits, Addison-Wesley, 1992.

22.10 Register Description

22.10.1

OCDR – On-chip Debug Register

The OCDR Register provides a communication channel from the running program in the micro-

controller to the debugger. The CPU can transfer a byte to the debugger by writing to this

location. At the same time, an internal flag; I/O Debug Register Dirty – IDRD – is set to indicate

to the debugger that the register has been written. When the CPU reads the OCDR Register the

7 LSB will be from the OCDR Register, while the MSB is the IDRD bit. The debugger clears the

IDRD bit when it has read the information.

In some AVR devices, this register is shared with a standard I/O location. In this case, the OCDR

access to the OCDR Register. In all other cases, the standard I/O location is accessed.

Refer to the debugger documentation for further information on how to use this register.

Bit

0x31 (0x51)

MSB/IDRD

LSB

OCDR

Read/Write

R/W

Initial Value

ATmega325P 데이터시트(PDF) 228 Page - ATMEL Corporation