ATtiny13A datasheet(93/174 Pages) ATMEL

93 / 174 page

8126D–AVR–11/09

ATtiny13A

• Bits 1:0 – MUX1:0: Analog Channel Selection Bits

The value of these bits selects which combination of analog inputs are connected to the ADC.

See Table 14-3 for details. If these bits are changed during a conversion, the change will not go

in effect until this conversion is complete (ADIF in ADCSRA is set).

14.12.2

ADCSRA – ADC Control and Status Register A

• Bit 7 – ADEN: ADC Enable

Writing this bit to one enables the ADC. By writing it to zero, the ADC is turned off. Turning the

ADC off while a conversion is in progress, will terminate this conversion.

• Bit 6 – ADSC: ADC Start Conversion

In Single Conversion mode, write this bit to one to start each conversion. In Free Running mode,

write this bit to one to start the first conversion. The first conversion after ADSC has been written

after the ADC has been enabled, or if ADSC is written at the same time as the ADC is enabled,

will take 25 ADC clock cycles instead of the normal 13. This first conversion performs initializa-

tion of the ADC.

ADSC will read as one as long as a conversion is in progress. When the conversion is complete,

it returns to zero. Writing zero to this bit has no effect.

• Bit 5 – ADATE: ADC Auto Trigger Enable

When this bit is written to one, Auto Triggering of the ADC is enabled. The ADC will start a con-

version on a positive edge of the selected trigger signal. The trigger source is selected by setting

the ADC Trigger Select bits, ADTS in ADCSRB.

• Bit 4 – ADIF: ADC Interrupt Flag

This bit is set when an ADC conversion completes and the data registers are updated. The ADC

Conversion Complete Interrupt is executed if the ADIE bit and the I-bit in SREG are set. ADIF is

cleared by hardware when executing the corresponding interrupt handling vector. Alternatively,

ADIF is cleared by writing a logical one to the flag. Beware that if doing a Read-Modify-Write on

ADCSRA, a pending interrupt can be disabled. This also applies if the SBI and CBI instructions

are used.

Table 14-3.

Input Channel Selections

MUX1..0

Single Ended Input

ADC0 (PB5)

ADC1 (PB2)

ADC2 (PB4)

ADC3 (PB3)

Bit

76543210

0x06

ADEN

ADSC

ADATE

ADIF

ADIE

ADPS2

ADPS1

ADPS0

ADCSRA

Read/Write

R/W

Initial Value

00000000

ATtiny13A 데이터시트(PDF) 93 Page - ATMEL Corporation

ATtiny13A 데이터시트(HTML) 93 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL